top of page
J. Olberg,
WA
"We machine a lift truck component from a titanium block measuring 6 "×7½ "×9 ". Our old process took 10 hours and required a number of tool changes. Now we mill the whole thing out in just 5 hours with one standard-length ½ " RampMill, and have increased tool life sixfold. It's a great value."
B. Lang,
UT
I am still on the same endmill for all these tests. The endmill shows no sign of wear. The corners at the bottom are as sharp as they were when they were new. I wouldn't believe it if hadn't seen it for myself."
D. Bronson,
WA
"That SwiftCARB endmill is a beast. Titanium’s no joke, so finding a tool that can rip through all four pockets and still look good is a big win."
G. Koenig,
OR
"SwiftCARB's 5 flute AF-5 series aluminum finishing end mills. The high flute count means the gullets can't take a big chip load, but the surface finishes are amazing and you can feed them about 40% faster than standard 3 flute carbide tools."
Check a Part Number
bottom of page